Our mounting systems firmly attach the pulls and plates to the door and are guaranteed for the life of the building.
Choose from a variety of pull positionings and plate sizes. Click on the drawings below to enlarge and print.
Location Standards
Positioning Applications
Sizing
Engraving
Door pulls to plates
Engraving on plates
Cutouts on plates
Cutout and Engraving on plates
Note: Be sure the pull you choose will fit on the plate, allowing for cutouts and/or engraving.
1 1/4" standard cylinder hole cutout size
3/8" diameter standard turn knob hole
Other cutout sizes and styles are readily available
3/4" high condensed block letters with black enamel fill
Other letter sizes and styles are readily available
ADA Accessibility Guidelines for Buildings and Facilities (ADAAG)
As amended through January 1998
4.13.9 Door Hardware. Handles, pulls, latches, locks, and other operating
devices on accessible doors shall have a shape that is easy to grasp with one hand and does
not require tight grasping, tight pinching, or twisting of the wrist to operate. Lever operated
mechanisms, push-type mechanisms, and U-shaped handles are acceptable designs. When sliding
doors are fully open, operating hardware shall be exposed and usable from both sides. Hardware
required for accessible door passage shall be mounted no higher than 48 in. (1220 mm) above finished floor.
Pull Positioning on Plates 4" or Less in Width
Pull Positioning on Plates Wider Than 4" (Handing Required)
Product Information
Sizing & Handing
